Subwoofer 2MHz Switching Amplifier

Integrating the Lipinski loudspeakers, subwoofers and power amplifiers into a perfectly time aligned and frequency calibrated system makes the entire monitoring chain the world's most linear and most accurate.

Time aligned satellites and woofers. Adding a subwoofer with its own preamp (having controls for level, frequency cut off, phase etc.) causes delay of the signal. This is called time smear. To compensate this inevitable delay requires moving the subwoofer several feet in front of the satellite - practically unrealistic. Using high-pass and low-pass filter cards within Lipinski amplifiers simultaneously for loudspeakers and subwoofers perfectly adjusts them in the time domain.

Ideally flat frequency response. The above mentioned cards perfectly match the loudspeakers with subwoofers for absolutely flat frequency response. No IC's are used, instead, it is designed with the patented Lipinski Square technology.

One-of-a-kind subwoofer amp in the industry. The L-300 delivers 150A of current and can work with loads as low as .5 Ohm. It uses dual topology - two separate 300W power amplifiers working in parallel mode. This is to increase damping factor - the single most important parameter for a subwoofer amplifier. In contrast, bridge mode used by most manufacturers lowers the damping factor. On top of this, the amount of output devices has been doubled.