Radial Engineering DiNET DAN-TX
UPC/EAN #676101044412
MPN #R800 1062
$599.99
Save 16.7%, MSRP $720.00
Dante network transmitter, stereo DI inputs and digital out
Developed by Audinate, Dante has become the standard for digital audio distribution in professional audio. Using standard Ethernet networks, any connected Dante device can communicate and route audio between each other with very little latency. The DAN-TX provides a simple way to put almost any analog audio source onto the Dante network without the need for a large interface or mixer.
The DAN-TX is equipped with ¼", RCA and 3.5mm inputs. When connecting a single-channel instrument such as a bass or acoustic guitar, an Instrument switch converts one of the ¼" jacks to a "Thru". This allows the player to connect to their amp for local monitoring like a typical DI box. With stereo sources, the selection of inputs provide an easy way to connect any device, whether it be a stereo keyboard or a tablet. The ¼" inputs will accept both balanced (TRS) for professional equipment, and unbalanced (TS) connectors for instruments or consumer gear. Levels can be controlled locally via an input trim pot that offers +/-10dB of control, with an additional -18dB pad that can be utilized when required. The DAN-TX can accept input levels up to +24dBU, and a high pass filter may be enabled to reduce unwanted low frequencies at the source.
The DAN-TX features 24bit/96kHz analog to digital converters for exceptional audio quality. Connecting to the Dante network is easy - simply connect its Ethernet jack to any networked audio system using standard Cat5e or Cat6 cable. The DAN-TX will accept Power over Ethernet (PoE), but a power adapter is included for use when PoE is not available. Once connected, the DAN-TX will appear as a 2-channel transmit device in the Dante Controller software and on other enabled devices on the network. Whether on stage, multi-room recording, or in broadcast, the DAN-TX is the easiest way to get your analog audio onto a Dante network.
Features
The first Dante? enabled direct box¼", RCA and 3.5mm input jacksConnect instruments or line level sources24bit/96kHz analog to digital conversion
Specifications
Specifications
Audio circuit type: High current balanced active input device
Number of channels: 2
Frequency response: 20Hz - 20kHz
Dynamic range: >103dB
Total harmonic distortion: 0.008% @ -6dBfs
Intermodulation Distortion: 0.0017% -10dBfs
Input Impedance: Unbal 240k (20k Line Mode), Bal 40k,
Noise: -98dB (EIN)
Noise: 44.1kHz, 48kHz, 88.2kHz, and 96kHz (24bit)
Features
Input pad, HPF, Level Control
Input Connectors: 1/4" TRS, 3.5mm & RCA
Output Connectors: RJ45 Ethernet
Extras: Instrument or Line Mode
General
Construction: 14-gauge steel
Size (L x W x D): 5" x 3.31" x 1.88" (12.7cm x 8.4cm x 4.8cm)
Weight: 1.45lb (0.66kg)
Shipping size (L x W x D): 11.75" x 4.75" x 3" (29.8cm x 12.1cm x 7.6cm)
Shipping weight: 2.1lb (0.95kg)
Power: 15VDC 400mA (included) or PoE
Conditions: For use in dry locations only between 5°C and 40°C
Write a review about the Radial Engineering DiNET DAN-TX
View more products from
Radial Engineering