DBX DriveRack 260
With the introduction of the new DBX DriveRack 260, the heritage of unrivaled system/loudspeaker control continues.
The DriveRack products provide the tools that ensure that the system sounds its very best. The 260 capitalizes on the road tested and contractor approved nature of the other products in the DriveRack line. The 260 provides full bandpass and crossover configurations as well as independent output processing and a full time RTA for live sound applications. Contractors will appreciate its control inputs for wall-panel logic control and the patent-pending Advanced Feedback Suppression (AFS).
The DriveRack 260 continues the legacy of DriveRack series, which has been created by the company that has been redefining the standard of signal processing for more than 30 years. The DriveRack 260 was designed with the purpose and vision of providing state-of-the-art signal processing, while utilizing a simple and intuitive user interface. This goal has been achieved by offering two independent channels of processing power with a linkable 28-Band Graphic Equalizer, industry-standard dbx stereo compressor module, feedback eliminator and the 120A Subharmonic Synthesizer on the input, with a six channel output system that includes parametric EQs, PeakStopPlus® limiters (to provide protection against speaker blowouts) and alignment delay. These features combined with the Wizard setup system and complete DriveWare GUI control represent a methodical design that is guaranteed to deliver optimal, all-inclusive processing in a completely scalable system.
Feedback Elimination2.7 Seconds of Alignment and Zone DelayRS-232 PC GUI controlClassic dbx Compression and LimitingGraphic and Parametric EQAuto-EQ FunctionFull Bandpass, Crossover, and Routing ConfigurationsAuto Gain ControlPink Noise Generator and fulltime RTASetup Wizard with JBL speaker and Crown Power Amplifier TuningsSecurity LockoutWall Panel Control Inputs
Input : (2) line inputs. (1) RTA Mic inputInput Connectors : (2) Female XLR line inputs. XLR RTA Mic inputInput Type : Electronically balanced/RF filteredInput Impedance : >40k ohmMax Input : +30dBu with input jumpers in +30 positionCMRR : > 45dBMic Preamp Phantom Power : +15VDC (RTA)Mic Preamp Equivalent Input Noise (EIN) : < -110dB, 22Hz-22kHz, 150 ohm (RTA)Output : 6 totalOutput Connectors : Male XLROutput Type : Electronically balanced, RF filteredOutput Impedance : 120ohmMax Output : +22dBuA/D Converter : dbx Type IV? Conversion SystemA/D Dynamic Range : (line) >113 dB, A-weighted, >110 dB unweightedType IV Dynamic Range : >119 dB, A-weighted, 22kHz BW; >117 dB, A-weighted, 22kHz BWSample Rate : 48kHzD/A Dynamic Range : 112 dB A-weighted, 109dB unweightedDynamic Range : >110 dB A-weighted, >107dB unweightedTHD+Noise : 0.003% typical at +4dBu, 1kHz, 0dB gainFrequency Response : 20Hz - 20kHz, +/- 0.5dBInterchannel Crosstalk : >110dB, 120dB typical, (input-to-output: >100dB)
View more products from DBX