The Furman M-8S is a 9 outlets sequential power conditioner that prevents excessive inrush currents.
Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.
Caractéristiques
Standard level AC protection and filtering.
Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only).
All settings and configurations available on rear panel.
15 amp rating.
Three year limited warranty.
Spécifications
Maximum Output Current: 15 amps, 120 VAC (Thermal breaker)
Line Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
AC Receptacles: Convenience Outlet (Front Panel) 1 Un-switched NEMA 15-5R, Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex), 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
Standard level AC Surge Protection : Merit Class (sacrificial)
Spike Protection Mode : Line to neutral, zero ground leakage
Max Continuous Operating Voltage : 130V RMS
Max Clamp Voltage : 500 Volts Peak
Peak Impulse Current : 12,000 Amps
Energy Rating (2 X 820μS) : 225 Joules
AC Filtering : Standard level Pi LCR Filter
Noise Attenuation : >26dB, 100 Khz to 1 MHz
Operating Temperature Range : 5C (40F) to 40C (105F) degrees
Humidity Range : <90% rH (Relative Humidity)
Rocker Switch : Front panel, Sequence (ON, OFF)
Thermal Circuit Breaker : Front panel, push to reset
Front Panel Indicators : Delay 1, Delay 2, Delay 3, Power, Protection OK