The Radial ProD2 is a high performance stereo direct box designed to easily interface keyboards to the PA and recording system without noise.
The Radial ProD2 is a compact stereo direct box developed specifically to address the needs and challenges of interfacing a stereo keyboard to a professional audio system. This passive DI features two independent channels with separate inputs and thru-puts for the artist's stage amp and two fully isolated outputs for the PA system.
At the heart of the design are two high performance Eclipse ET-DB2 transformers. These deliver 20Hz to 20kHz performance with less than 1.5dB deviation above 18kHz and are able to withstand tremendous signal levels without distortion. Unlike active circuits that overload when the signal exceeds the rail voltage, transformers saturate. This creates a pleasing effect that naturally rounds out the tone, acting like a subtle limiter which is particularly advantageous when interfacing the ProD2 with digital pianos, samplers and drum machines that can produce excessive dynamics. Transformers are particularly adept at eliminating hum and buzz caused by ground loops.
As with all Radial products, the ProD2 is built tough to handle the rigors of professional touring. A 14-gauge steel ultra rigid i-beam skeleton frame eliminates opportunity from outside stress to flex the sensitive PC board and cause premature solder joint failure. The innovative book-end design creates a protective zone around the connectors and switches further increasing lifespan. And a full bottom no-slip pad adds mechanical isolation and electrical insulation to further reduce opportunity for noise.
The Radial ProD2's warm sound, legendary build quality and compact design have made it the most popular stereo direct box made today.
Stereo direct box designed for keyboards
Smooth, warm sound rounds out digital edge
Able to handle huge transients without choking
May be rack mounted for touring rigs
Audio circuit type : Passive, transformer based
Number of channels : Dual mono
Frequency response : 20Hz ~ 18.5KHz (± 0.2dB)
Dynamic range : 128dB
Maximum input : +18dB @ 20Hz
Total harmonic distortion : 0.01% from 20Hz~20kHz @-10dB
Phase deviation : 1° @ 100Hz; 8° @ 20Hz
Input impedance : 140k Ohms, unbalanced
Output impedance : 150 Ohms, balanced
Transformer : Eclipse ET-DB2, 12:1 ratio
Shield : Faraday, MuMETAL® can
Input pad : -15dB
180° polarity reverse : Inverts absolute phase
Ground lift : Disconnects pin-1 at XLR output
XLR configuration : AES standard (pin-2 hot)
Connectors : 1/4" in & thru, XLR-M out
Construction : 14 gauge steel chassis & outer shell
Finish : Durable powder coat
Size : (W x H x D) 70 x 108 x 44mm (2.75" x 4.25" x 1.75")
Weight : .54kg (1.2lbs)
Shipping size: W x H x D : 102 x 76 x 165mm (4.00" x 3.00" x 6.50")
Shipping weight : 0.61 kg (1.35 lbs)
Power : Passive, no power required
Conditions : For use in dry locations only between 5°C and 40°C