Rednet HD32R

Allows Dante Ethernet-based audio networking products to interoperate fully with Pro Tools|HD & Pro Tools|HDX

Ethernet and power supply redundancy with auto switchover in case of failure and locking connectors

Provides the vital link to create an extensive high-quality audio network based on standard Cat 5e or Cat 6 wiring, bringing the latest advances in digital audio networking to Pro Tools|HD

Cost-effectively increase audio I/O quality and flexibility with RedNet interfaces

Permits multiple workstations to access the same interface hardware and I/O

No changes to Pro Tools workflow required - simple, logical assignment of RedNet I/O to Pro Tools|HD inputs and outputs

Up to 32 I/O with Pro Tools|HD over single DigiLink connection per RedNet HD32R

Additional Avid/Digidesign interfaces may be connected to expansion ports

Upgrade to RedNet interfaces while remaining fully compatible with TDM- or AAX-DSP-based plugins and saved sessions

Digital Performance

Supported Sample Rates : 44.1 / 48 / 88.2 / 96 / 176.4 / 192 kHz (-4% / -0.1% / +0.1% / +4.167%) at 24 bit

Clock Sources : Internal, Word Clock, Loop Sync (master or slave) or from Dante Network Master.

External Word Clock Range : Nominal sample rate ±7.5%

Rear Panel Connectivity

Pro Tools|HD

Primary Port : 1 x Mini DigiLink

Expansion Port : 1 x Mini DigiLink

Loop Sync

Word Clock Input : 1 x BNC 75 port

Word Clock Output : 1 x BNC 75 port

Word Clock

Word Clock Input : 1 x BNC 75 port (switchable termination)

Word Clock Output : 1 x BNC 75 port

PSU & Network Connections

PSU : 2 x IEC Inputs with retaining clips.

Network : 2 x etherCON connectors, also compatible with standard RJ45 connectors.

Front Panel Indicators

Primary PSU (A) : Green LED. Illuminates when an AC input is applied and all DC outputs are present.

Primary PSU (B) : Green LED. Illuminates when an AC input is applied and all DC outputs are present.

Primary Network : Green LED. Indicates that a network connection is present on primary port when in redundant mode. When in Switched mode, a valid network connection at either Primary or Secondary network port will cause this LED to illuminate.

Secondary Network : Green LED. Indicates that a network connection is present on secondary port when in redundant mode. Not used in switched mode.

Network Locked : Green LED. When unit is network slave, shows valid network lock. When unit is network master, shows lock to indicated clock source. Flashing indicates external clock is selected but not connected.

Sample Rate : Orange LED for each: 44.1 kHz, 48 kHz, x2, x4.

Pull Up/Down : Orange LED. Indicates unit is set to operate on a Dante pull up/down domain.

Signal Indicators : 16 Green LEDs, 8 input/8 output indicators. Illuminate @ -126dBFS.

Clock Source : Orange LED for each: Internal, Word Clock, Loop Sync and DAW Master.

Network Modes

Redundant : Allows unit to connect two independent networks.

Switched : Connects both ports to integrated network switch allowing daisy-chaining of device.

Dimensions

Height : 44.5mm/ 1.75"

Width : 482.6mm/ 19"

Depth : 263mm/ 10.35"

Weight : 3.9kg

Power

PSU : 2 x Internal, 100-240V, 50/60Hz, consumption 30VA.